top of page
SXC Sphere Download.png

Commando 961 SXCar Software

SXCar is SCS Delta's bespoke dealer tool.

Its a simple user-friendly windows application that communicates with Norton Commando 961 SC ECUs via our USB CAN interface.

SC supplied over 800 ECUs to Norton between September 2012 and January 2016 with serial numbers between 9176758 and 9178569. The 'Typhoon V4' ECU was supplied to Norton ‘locked down’ so that communications were only possible using dealer software, SXCar. The software shows all engine sensor parameters, allows for an idle reset to be performed and allows for upload of different calibrations.
NB! This SXCar software only works with the original locked SC ECU. If the ECU has been unlocked or you have a Delta 400 then you must use SXTune, as SXCar will not connect.

Download idle set procedure PDF

Software Installation

 

This installation can be used to upgrade any previous version of

SXCar, the previous version should be uninstalled before upgrading. 

To install the SXCar Calibration and Configuration tool on your PC please double click the setup file and follow the on-screen prompts. SXCar will then be installed onto your PC. If you have been supplied with or have downloaded a map for your ECU please copy this to the folder ‘My Documents\SXCar Calibrations” on your PC.

N.B. You must be logged into your PC as an administrator to install SXCar. If you are not logged on as an administrator on your PC the installer will give the error message ‘Access Denied’. You can then right-click on the setup file and select ‘Run as administrator’ to avoid this. 

SXCar is suitable only for use with Microsoft Windows  8 or 10 operating systems and can operate on both 32 and 64 bit. Note that Windows needs to be up to date before installing our software and an internet connection is required during the installation process.

Windows is a registered trademark of Microsoft Corporation in the United States and other countries.

bottom of page